
Automotive Rubber Pads, Stoppers & Caps
Support pads, step pads, glove-box and tailgate stoppers, oil filler caps and A/C and radiator shroud flaps, moulded in Nashik against controlled drawings for vehicle makers and their Tier 1 and Tier 2 suppliers.
- EPDM · NBR · NR
- Drawing-controlled
- First-article approval
Margo Rubber Products moulds automotive rubber pads, stoppers and caps in EPDM, NBR and natural rubber to the customer's controlled drawing, including the Bolero support pad and side step pad. Each part is approved as a first-article sample before volume release. Minimum run 10,000 pieces per part number, per compound; installed capacity 5 million parts a month; quotation in 48 hours.
AUTOMOTIVE PADS AND STOPPERS WE MOULD
Small parts, made by the hundred thousand.
These are the parts a vehicle needs in the largest numbers. They are made against a controlled drawing revision, with no substitutions without approval.

01
Bolero support pad
Support pad made against a controlled drawing for a utility-vehicle line.
View product
02
Rubber support pad
Load-bearing support pad that isolates a panel or bracket from vibration.
View product
03
Side step pad
Anti-slip step pad for utility and commercial vehicles.
View product
04
Glove-box stopper
Small interior stopper that stops rattle on a closing lid.
View product
05
Radiator shroud flaps
EPDM flaps that direct air through the radiator and A/C condenser.
View product
06
Pads, stoppers & caps
Support pads, glove-box stoppers, filler caps and shroud flaps to drawing.
View product
COMPOUND AND CONTROL
Chosen for the position.
A cabin stopper and an under-bonnet flap look alike on a drawing and need different compounds.
Under the bonnet
EPDM for shroud flaps and air guides near the radiator; NBR where oil reaches a filler cap.
In the cabin
Natural rubber and EPDM stoppers tuned so a lid or door closes quietly without rattle.
Volume and spare capacity
Installed capacity is 5 million parts a month against about 1.5 million in current production. The minimum run is 10,000 pieces per part number, per compound.
Checked through the run
Every mixed batch is checked, every run at set-up and every half hour, and every despatch lot for dimensions and hardness. Target rejection is under 1%; on-time delivery is over 99%.
WHERE OUR PADS ARE FITTED
Body, cabin and engine bay.
Body and chassis
Support pads, side step pads and bumper stoppers on utility and commercial vehicles.
Cabin
Glove-box stoppers, tailgate switch boots and trim buffers.
Engine bay
Oil filler caps, insulator head covers and radiator shroud flaps.
A/C and air management
A/C air-extractor flaps and air guides in EPDM.
FREQUENTLY ASKED QUESTIONS
Questions from automotive buyers.
Can you make a support pad to an OEM drawing?
Yes. The Bolero support pad and side step pad are made that way: against a controlled drawing revision, with a first-article sample approved before volume release. A change to compound, hardness or geometry is quoted and approved as a change, never made silently.
Which rubber is used for automotive support pads?
EPDM where the pad sees weather, sun and road water; natural rubber where it carries load and must recover; NBR where oil or fuel can reach it. We propose the compound and hardness against the position on your drawing.
What volumes can you take on?
The minimum run is 10,000 pieces per part number, per compound. Installed capacity is 5 million parts a month against about 1.5 million in current production. Production takes three to four weeks from drawing approval.
MORE FOR AUTOMOTIVE BUYERS
Automotive rubber parts by part and location
Send the drawing or the part.
The controlled drawing or a sample, with the position on the vehicle and the annual volume. We reply within 48 hours with a compound and a quotation.
